Page 1 of 1
The voice VLAN feature is provided to separate voice traffic from data traffic and assign higher priority to voice traffic, thus decreasing voice transmission delay and jitter.You can assign or remove a port to or from the voice VLAN manually or have the switch do that dynamically by configuring the...
Multiple VLAN Registration Protocol (MVRP) formerly known as GARP VLAN Registration Protocol (GVRP) or Generic VLAN Registration Protocol is a standards-based Layer 2 network protocol, for automatic configuration of VLAN information on switches. It was defined in the 802.1ak amendment to 802.1Q-2005.Within...
Network DiagramFigure 6 Network diagram for super VLAN configurationNetwork RequirementsAs shown in Figure 6, Switch A works at the distribution layer to distribute traffic for the numerous hosts attached to the access switches connected to Switch A. All the hosts are assigned IP addresses from network...
Network DiagramFigure 4 Network diagram for IP subnet-based VLAN configurationNetwork RequirementsAs shown in Figure 4, hosts in the office area are configured on two network segments 192.168.5.0/24 and 10.200.50.0/24. Configure IP subnet-based VLANs on the switch to enable GigabitEthernet 1/0/1 of the...
Network DiagramFigure 3 Network diagram for protocol-based VLAN configurationNetwork RequirementsAs shown in Figure 3, configure protocol-based VLANs on the switch to satisfy the following requirements:l IPv4 hosts in the office area and lab area can communicate with the IPv4 server; IPv6 hosts in...
Network DiagramFigure 1 Network diagram for port-based VLAN configurationNetwork Requirementsl As shown in Figure 1, Switch A and Switch B connect to Host 1 and Server 1 of a department and Host 2 and Server 2 of another department.l To isolate the communication between the two departments...
